Programming
38
L
The next step must be completed
within 90 seconds.
4
Handset:
M
s
Wait until
“
Base PIN
”
is
displayed.
s
Enter the base unit
PIN (default:
“
0000
”
).
s
M
L
If you forget your PIN, contact an
authorised service centre.
L
When the handset has been
registered successfully,
w
is
displayed.
Note:
L
While registering,
“
Base in
registering
”
is displayed on all
registered handsets.
L
When you purchase an additional
handset, refer to the additional
handset’s installation manual for
registration.
Selecting a base unit
When
“
Auto
”
is selected, the handset
automatically uses any available base
unit it is registered to. When a specific
base unit is selected, the handset makes
and receives calls using that base unit
only. If the handset is out of range of that
base unit, no calls can be made.
1
1
(middle soft key)
y
137
2
{
r
}
: Select the desired base unit
number, or
“
Auto
”
.
s
M
L
The handset starts searching for
the base unit.
Deregistering a handset
A handset can cancel its own
registration to the base unit, or other
handsets registered to the same base
unit. This allows the handset to end its
wireless connection with the system.
1
1
(middle soft key)
y
131
L
All handsets registered to the
base unit are displayed.
2
{
r
}
: Select the handset you want to
cancel.
s
M
3
{
r
}
:
“
Yes
”
s
M
L
A confirmation tone sounds.
L
The handset does not beep when
cancelling its own registration.
4
{i
c
}
Cancelling a base unit
A handset can cancel a base unit that it
is registered to. This allows the base unit
to end its wireless connection with the
system.
1
1
(middle soft key)
y
139
2
{
r
}
: Select the base unit you want to
cancel.
s
M
3
{
r
}
:
“
Yes
”
s
M
s
{i
c
}
Note:
L
To register a handset to another base
unit or to the same base unit again,
see page 37.
Increasing the range of the
base unit
You can increase the signal range of the
base unit by using a DECT repeater.
Please use only the Panasonic DECT
repeater noted on page 4. Contact your
Panasonic dealer for details.
Important:
L
Before registering the repeater to this
base unit, you must turn the repeater
mode on.
L
Do not use more than one repeater at
a time.
Setting the repeater mode
1
1
(middle soft key)
y
138
2
{
r
}
: Select the desired setting.
s
M
s
{i
c
}
TG862xAZ(e).book Page 38 Thursday, May 12, 2011 1:39 PM
