– 6 –
Frequently asked questions
Question
Cause/solution
Why is
w
flashing?
L
The handset is too far from the base unit. Move
closer.
L
The base unit’s AC adaptor is not connected.
Check the connections.
L
You are using the handset or base unit in an area
with high electrical interference. Place the base
unit and use the handset away from sources of
interference.
L
The handset is not registered to the base unit.
Register it (page 8).
Why can I not make calls?
L
The dialling mode may be set incorrectly. Change
the setting (page 4).
Why is the handset display
blank or goes dark when on
a call?
L
The handset is in screen saver mode. Activate the
handset display again by:
– pushing the joystick left
{
<
}
or right
{
>
}
when
on a call.
– pressing
{ih}
at all other times.
L
“
LCD Dimming
”
is set to
“
Off
”
while on charge.
Change the setting.
What should I do when the
handset does not turn on?
L
Make sure the batteries are installed correctly.
L
Fully charge the batteries.
L
Clean the charge contacts and charge again.
How long is the battery
operating time?
L
When you are using fully-charged Ni-MH batteries
(supplied batteries);
In continuous use: 15 hours max.
Not in use (standby): 250 hours (10 days) max.
L
It is normal for batteries not to reach full capacity
at the initial charge. Maximum battery
performance is reached after a few complete
cycles of charge/discharge (use).
L
Actual battery performance depends on a
combination of how often the handset is in use
and how often it is not in use (standby).
Can I keep the handset on
the base unit or charger
when I am not using it?
L
Even after the handset is fully charged, the
handset can be left on the base unit or charger
without any ill effect on the batteries.
When should I replace the
batteries?
L
If the batteries are fully charged until
&
is
displayed, but
)
is displayed after a few calls,
replace the batteries with new ones.
TG8301_8321FX(e)_QG.fm Page 6 Tuesday, April 1, 2008 11:06 AM
