Panasonic KX-TG8011MES, Service Manual

Page: 57 / 85

57
KX-TG8011MES/KX-TGA800MES
11.5. Things to Do after Replacing IC or X'tal
Cautions:
Some of the content on this page may not apply to models from some countries. The contents below are the minimum adjust-
ments required for operation.
11.5.1. Base Unit
Before making the following adjustment, ensure you have carried out PC Setting (P.51) in The Setting Method of JIG (Base
Unit) .
Note:
(*1) XX: country code, YY: revision number
“XX” and “YY” vary depending on the country version. You can find them in the batch file, PQZZ- mentioned in
JIG and PC
(P.51).
(*2) Refer to
Check Point (Base Unit) (P.40)
Items Necessary Adjustment
BBIC (FLASH type)
(IC7)
Programs for Voice processing, interface for RF
and EEPROM 1. Make sure to connect the JIG cable, then detach the DC
Power.
2. Execute the command “flw480 *********.hex”.
3. Connect the DC Power.
4. Press the PC Enter key once.
5. After a few minutes, “Successful upgrade” is displayed
on the PC indicating downloading has finished.
6. Detach the JIG cable, then disconnect the DC Power.
7. Connect the DC Power.
8. Connect the JIG cable again, and execute the command
“getchk”, then confirm the checksum value is correct.
• If the downloading fails, start again from step 1.
9. Default batch file: Execute the command “default.bat”.
10. Country version batch file: Execute the command
“TG7300XXrevYY.bat”. (*1)
11. Clock adjustment: Refer to Check Point (G). (*2)
EEPROM
(IC401) Adjustment parameter data
(country version batch file, default batch file,
etc.) 1. Change the address “0000” of EEPROM to “00”.
2. Default batch file: Execute the command “default.bat”.
3. Country version batch file: Execute the command
“TG7300XXrevYY.bat”. (*1)
4. Clock adjustment: Refer to Check Point (F). (*2)
X'tal (X1) System clock 1. Refer to Check Point (G). (*2)