Panasonic KX-TG7842C, Operating Instructions Manual, Page: 46 / 84

want to be disturbed, for example, while
sleeping. Night mode can be set for each unit.
Important:
R Set the date and time beforehand
(page 17).
R If you have set the alarm, the alarm sounds
even if the night mode is turned on.
Turning night mode on/off
Handset
1
M MENU N#238
2
MbN : Select the desired setting. a
M SAVE N
R If you select “
Off
” , press M OFF N to
exit.
3
Enter the desired hour and minute you
wish to start this feature.
4
* : Select “
AM
” or “
PM
” . a M OK N
5
Enter the desired hour and minute you
wish to end this feature.
6
* : Select “
AM
” or “
PM
” .
7
M SAVE N a M OFF N
R When the night mode is set, is
displayed.
Base unit
1
M MENU N#238
2
MbN : Select the desired setting. a
M SAVE N
R If you select “
Off
” , press M EXIT N to
exit.
3
Enter the desired hour and minute you
wish to start this feature.
4
M AM/PM N : Select “
AM
” or “
PM
” . a M OK N
5
Enter the desired hour and minute you
wish to end this feature.
6
M AM/PM N : Select “
AM
” or “
PM
” .
7
M SAVE N a M EXIT N
R When the night mode is set, is
displayed.
Changing the start and end time
Handset / Base unit
1
M MENU N#237
2
Continue from step 3 for handset or step
3 for base unit, “Turning night mode on/
off”, page 46.
Changing the handset name
Each handset can be given a customized
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is
“
No
” . If you select
“
Yes
” without entering any handset name,
“
Handset 1
” to “
Handset 6
” is displayed.
Handset
1
M MENU N#104
2
Enter the desired name (max. 10
characters; see the character table,
page 33).
R If not required, go to step 3.
3
M SAVE N
4
MbN : Select the desired setting. a
M SELECT N 2 times
5
M OFF N
Call block (Call Display
subscribers only)
This feature allows the unit to reject calls when:
– the unit receives a call from a phone
number stored in the call block list as
unwanted (“Storing unwanted callers”,
page 47).
– the unit receives a call without phone
number (“Blocking incoming calls without
phone number”, page 47).
When a call is received, the unit rings for a
short time
*1
while the caller is being identified.
If the phone number matches an entry in the
call block list, the unit emits no sound to the
caller, and disconnects the call.
46
Programming
TG78xxC(en)_1221_ver013.pdf 46 2012/12/21 11:21:31