Programming
30
used. If a handset moves out of range of
its base unit when
“
Auto
”
is selected on
base unit (page 30), it looks for another
base unit to make or receive calls. A
base unit and the handsets it
communicates with is called a “radio
cell”.
Note:
L
Calls are disconnected when the
handset moves from one radio cell to
another.
Registering a handset to a
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example,
_
is displayed even when
the handset is near the base unit), re-
register the handset.
1
Handset:
1
i
{
#
}{
1
}{
3
}{
0
}
2
{V}
/
{^}
: Select a base unit number.
i
M
L
This number is used by the
handset as a reference only.
3
Base unit:
Press and hold
{x}
for about 5
seconds, until the registration tone
sounds.
L
If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L
The next step must be completed
within 90 seconds.
4
Handset:
Wait until
“
Base PIN
”
is displayed.
i
Enter the base unit PIN (default:
“
0000
”
).
i
M
L
If you forget your PIN, contact an
authorised service centre.
L
When the handset has been
registered successfully,
w
is
displayed.
Note:
L
While registering,
“
Base in
registering
”
is displayed on all
registered handsets.
L
When you purchase an additional
handset, refer to the additional
handset’s installation manual for
registration.
Selecting a base unit
When
“
Auto
”
is selected, the handset
automatically uses any available base
unit it is registered to. When a specific
base unit is selected, the handset makes
and receives calls using that base unit
only. If the handset is out of range of that
base unit, no calls can be made.
1
1
i
{
#
}{
1
}{
3
}{
7
}
2
{V}
/
{^}
: Select the desired base
unit number, or
“
Auto
”
.
i
M
L
The handset starts searching for
the base unit.
Deregistering a handset
A handset can cancel its own
registration (or the registration of
another handset) that is stored to the
base unit. This allows the handset to end
its wireless connection with the system.
1
1
i
{
#
}{
1
}{
3
}{
1
}
L
All handsets registered to the
base unit are displayed.
2
{V}
/
{^}
: Select the handset you
want to cancel.
i
M
3
{V}
/
{^}
:
“
Yes
”
i
M
L
A confirmation tone sounds.
L
The handset does not beep when
cancelling its own registration.
4
{i
c
}
Cancelling a base unit
A handset can cancel a base unit that it
is registered to. This allows the base unit
TG7522_7523AL(e).book Page 30 Monday, February 8, 2010 1:29 PM
