Panasonic KX-TG7100HGS, Service Manual

Page: 52 / 79

52
KX-TG7100HGS/KX-TG7102HGS/KX-TGA711FXS
11.6. Things to Do after Replacing IC
Cautions:
Some of the content on this page may not apply to models from some countries.
11.6.1. Base Unit
Before making the following adjustment, ensure you have carried out PC Setting (P.45) in The Setting Method of JIG (Base
Unit) .
Note:
(*1) XX: country code, YY: revision number
“XX” and “YY” vary depending on the country version. You can find them in the batch file, PQZZ- mentioned in
JIG and PC
(P.45).
(*2) Refer to
Check Point (Base Unit) (P.32)
11.6.2. Handset
Before making the following adjustment, ensure you have carried out Batch file Settings (P.46) in The Setting Method of JIG
(Handset) .
Note:
(*3) XX: country code, YY: revision number
“XX” and “YY” vary depending on the country version. You can find them in the batch file, PQZZ- mentioned in
JIG and PC
(P.45).
(*4) Refer to Check Point (Handset) (P.36)
IC Necessary Adjustment
BBIC
(IC7) Programs for Voice processing, interface for RF and
EEPROM 1. Default batch file: Execute the command “default.bat”.
2. Country version batch file: Execute the command
“TG8100XXrevYY.bat”. (*1)
3. Clock adjustment: Refer to Check Point (F). (*2)
EEPROM
(IC5) Adjustment parameter data
(country version batch file, default batch file, etc.) 1. Change the address “0000” of EEPROM to “AA”.
2. Default batch file: Execute the command “default.bat”.
3. Country version batch file: Execute the command
“TG8100XXrevYY.bat”. (*1)
4. Clock adjustment: Refer to Check Point (F). (*2)
IC Necessary Adjustment
BBIC
(IC1) Programs for Voice processing, interface for RF and
EEPROM 1. Default batch file: Execute the command “default.bat”.
2. Default batch file (remaining): Execute the command
“TGA711DEFrevYY.bat”.(*3)
3. Country version batch file: Execute the command
“TGA711XXrevYY”. (*3)
4. Clock adjustment: Refer to Check Point (J). (*4)
5. 1.8 V setting and battery low detection: Refer to Check
Point (A), (H) and (I). (*4)
EEPROM
(IC3) Adjustment parameter data
(country version batch file, default batch file, etc.) 1. Change the address “0015” of EEPROM to “00”.
2. Default batch file: Execute the command “default.bat”.
3. Default batch file (remaining): Execute the command
“TGA711DEFrevYY.bat”.(*3)
4. Country version batch file: Execute the command
“TGA711XXrevYY”. (*3)
5. Clock adjustment: Refer to Check Point (J). (*4)
6. 1.8 V setting and battery low detection: Refer to Check
Point (A), (H) and (I). (*4)