Useful Information
42
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Programmable settings
The unit does not work.
L
Make sure the batteries are installed correctly (page 12).
L
Fully charge the batteries (page 12).
L
Check the connections (page 11).
L
Unplug the base unit’s AC adaptor to reset the unit and turn off
the handset. Reconnect the adaptor, turn on the handset and
try again.
L
The handset has not been registered to the base unit. Register
the handset (page 29).
The handset display is
blank.
L
The handset is not turned on. Turn the power on (page 16).
I cannot hear a dial tone.
L
Make sure that you are using the supplied telephone line cord.
Your old telephone line cord may have a different wiring
configuration.
L
The base unit’s AC adaptor or telephone line cord is not
connected. Check the connections.
L
Disconnect the base unit from the telephone line and connect
the line to a known working telephone. If the working
telephone operates properly, contact our service personnel to
have the unit repaired. If the working telephone does not
operate properly, contact your service provider/telephone
company.
Problem
Cause/solution
The display is in a
language I cannot read.
L
Change the display language (page 16).
While programming, the
display returns to standby
mode.
L
A call matching an entry in the call barred list is being received.
Wait and try again later.
I cannot activate the eco
mode.
L
You cannot set eco mode when you set the repeater mode
“
On
”
. If required, set the repeater mode to
“
Off
”
(page 29).
I cannot register a
handset to a base unit.
L
The maximum number of handsets (6) is already registered to
the base unit. Cancel unused handset registrations from the
base unit (page 29).
L
You entered the wrong PIN. If you forget your PIN, see “I
cannot remember the PIN.” (page 42).
I cannot remember the
PIN.
L
Change the PIN using the following method.
1
8
(
132
2
*
7
)))
3
Enter the new 4-digit base unit PIN.
s
M
s
{i
c
}
Problem
Cause/solution
TG6611-6621E(e).book Page 42 Tuesday, December 7, 2010 2:00 PM
