4
M
AM/PM
N
: Select
“
AM
”
or
“
PM
”
.
a
M
OK
N
5
Enter the desired hour and minute you wish to
end this feature.
6
M
AM/PM
N
: Select
“
AM
”
or
“
PM
”
.
7
M
SAVE
N
a
M
EXIT
N
Changing the start and end time
Handset / Base unit
1
M
MENU
N#237
2
Continue from step 3 for handset or step 3 for
base unit, “Turning night mode on/off”,
page 45.
Selecting groups to bypass night mode
Handset / Base unit
1
M
MENU
N#241
2
MbN
: Select the desired group.
a
M
SELECT
N
R
“ ” is displayed next to the selected group
numbers.
R
To cancel the selected group:
MbN
: Select the group.
a
Press
M
SELECT
N
again. “ ” disappears.
3
M
SAVE
N
4
Proceed with the operation for your unit.
Handset:
M
OFF
N
Base unit:
M
EXIT
N
Baby monitor
This feature allows you to listen in on a room
where another handset is located, allowing you to
easily monitor from different areas of the house or
place. The monitored handset (placed in a baby’s
room, for example) will automatically call the
monitoring handset, base unit, or the phone
number stored when it detects sound.
Important:
R
You should perform a test run of the baby
monitor procedure to ensure that the baby
monitor feature is set correctly. For example,
test its sensitivity. Check the connection if you
are diverting the baby monitor to an outside line.
R
This feature should not be used as a substitute
for a medical or caregiver’s supervision. It is the
caregiver’s responsibility to stay close enough
to handle any eventuality.
Note:
R
If the unit is connected to a PBX system, you
cannot set the baby monitor.
R
During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset on
charger.
R
The monitored handset never rings while it is
being monitored. If the base unit is placed near
the monitored handset, we recommend turning
off the base unit ringer volume (page 39, 41)
Setting the baby monitor
Perform the setting operation with the handset to
be monitored (for example, the handset placed in
a baby’s room).
To monitor with a unit
The internal baby monitor feature is available:
– between handsets
– between a handset and the base unit
Handset
1
M
MENU
N#268
2
MbN
:
“
On
”
a
M
SELECT
N
3
MbN
: Select the desired unit’s number to
monitor with.
a
M
SAVE
N
R
“
Baby monitor
”
will be displayed.
R
The registered unit’s name/number is
displayed.
Note:
R
When this feature is on, another handset or the
base unit can hear the monitored handset by
making an intercom call.
To monitor from an outside line
If you enable this feature, the unit will call a
pre-programmed phone number when the handset
detects sound. After you answer the call, you can
listen in on the room where the handset is located.
This feature is only available for landline.
Handset
n
From the phonebook:
1
M
MENU
N#268
2
MbN
:
“
On
”
a
M
SELECT
N
3
MbN
: Select
“
Outgoing call
”
to monitor
from an outside line.
a
M
EDIT
N
a
M
ADD
N
46
For assistance, visit www.panasonic.ca/english/support
Programming
TG153CSK(en)_0422_ver021.pdf 46
2016/04/22 14:54:43
