Panasonic KX-PS8000, Reference Manual

Page: 143 / 155

143
Troubleshooting
Error message Possible cause Recovery
Printer Driver for Windows NT 4.0
Can not initialize ASPI for
Windows. Install newer
version of ASPI for
Windows.
SCSI Board and its driver are not
installed correctly. Correctly install SCSI board and its driver.
(Refer to the instructions manual of the
SCSI board.)
Wnaspi32.dll will be installed or replaced
with a new version.
For any other trouble related to SCSI,
refer to the SCSI section of
Troubleshooting
( ☞ P.147) .
ASPI Manager is not
found. Install ASPI for
Windows. (e.g. install
wnaspi32.dll to your
system32 directory). SCSI Board and its driver are not
installed correctly. Correctly install SCSI board and its driver.
(Refer to the instructions manual of the
SCSI board.)
Wnaspi32.dll will be installed or replaced
with a new version.
Perform the following procedure.
1. Confirm that the terminator is correctly
set.
2. Confirm that the printer is ready.
3. Confirm that the printer is correctly
connected with a SCSI cable.
4. Turn off the computer, then turn it on
again.
The ASPI for Windows
installed on this PC does
not have expected
function. Install newer
version of ASPI for
Windows.
The ASPI for Windows
installed on this PC does
not support expected
mode. Install newer
version of ASPI for
Windows.
The ASPI for Windows
installed on this PC does
not support Windows.
Install ASPI for Windows.
[e.g.install wnaspi32.dll to
your system32 directory]
Error writing to LPT1: for
“Application name”: The
device is not ready. Do
you wish to retry or
cancel the job? Connect the printer (parallel cable)
correctly or make the printer ready. Cable connection is improper or
printer is not ready.
B
Cable connection is improper or
printer is not ready.
B
The terminator setting is
improper.
Error writing to “Port
name” for “Application
name”: The request could
not be performed
because of an I/O device
error. Do you wish to retry
or cancel the job?
Error writing to
KXPS8000GDI: for <
print job
name
>: The printer command
is invalid. Do you wish to
retry or cancel the job?
Separator page has been set.
When SCSI port is used, Separator
page cannot be used. Cancel the Separator page setting.