Panasonic KX-NS1000, Pc Programming Manual, Page: 400 / 1294

Announce Mode
Specifies if the IP-CS’s (KX-NS0154 only) built-in ANNOUNCE feature is enabled. An IP-CS (KX-NS0154 only)
in a remote location with ANNOUNCE enabled can provide the PBX’s IP Address information to other terminals
in the remote location in place of manually programming the PBX’s IP address at each terminal.
Default
Disable
Value Range
Disable, Enable
Maintenance Console Location
9.19 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Port Property
Secondary Setting
The settings on this screen are for programming the Automatic Rerouting to Secondary PBX feature for use
among IP-CSs (KX-NS0154 only) in a networked environment. For details and conditions regarding the use
of this feature, refer to
2.1.7 Automatic Rerouting to Secondary PBX in the Feature Manual.
Setting Secondary Ports
Follow the steps below to designate secondary ports for IP-CSs.
1.
Specify the secondary ports.
a.
Access the port property screen of the site where the ports will be set as secondary ports.
b.
In Primary/Secondary , set the unused ports that will be used as secondary ports to "Secondary".
Note
Ports that have already been registered (A value other than the default of "00:00:00:00:00:00" is
set for
MAC Address on the Main tab) cannot be set to "Secondary" here.
2.
Access the port property screen of the site where primary ports will be assigned secondary ports.
3.
Click Set Secondary . A dialog box will appear.
4.
From the drop-down list, select a site where secondary ports will be assigned.
Note
The number displayed for Available ports indicates the maximum number of available ports at the
selected site that can be registered as secondary ports.
5.
IP-CSs’ primary ports and names are displayed on the left. Select the IP-CSs for which to want to register
secondary ports, and then click the right arrow.
Note
Ports that are already assigned as secondary ports will not be displayed in this list.
6.
Click Execute . A message confirming the registration will be displayed.
7.
Repeat steps 2 – 6 for each site where you want to designate secondary ports.
Removing Secondary Port Settings
Follow the steps below to remove secondary port settings for IP-CSs.
1.
Click Remove Secondary . A dialog box will appear.
2.
Primary ports of IP-CSs that have secondary ports assigned are displayed on the left. Select the IP-CSs
whose secondary setting you want to remove, and then click the right arrow.
3.
Click Execute . A message confirming the setting removal will be displayed.
400 PC Programming Manual Document Version 2016-03
9.19 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Port Property