Panasonic KX-NS1000, Pc Programming Manual

Page: 394 / 1294

9.19 PBX Configuration—[1-1]
Configuration—Slot—V-IPCS4—Port Property
Various settings can be programmed for each virtual IP-CS port.
IP-CS Registration and De-registration
An IP-CS must be registered to the PBX by programming the PBX and IP-CS before it can be used.
Programming instructions for the PBX are given below.
It is possible to de-register the IP-CS later.
IP-CS Registration, De-registration, and Forced De-registration can be performed only in On-line mode.
Note
Registration, De-registration, and Forced De-registration cannot be performed for ports set as secondary
IP-CSs. For details, see
Secondary Setting below.
Preparation
Open 28.1 Network Service—[1] IP Address/Ports—Basic Settings , and confirm that the IP addresses of
the mother board and DSP card, subnet mask address, and default gateway address are set.
Registration
Follow the steps below to register the IP-CS.
1.
Connect the IP-CS to be registered to the network and, if necessary, the power supply.
2.
Click Registration .
A dialog box will appear. Non-registered (available) IP-CSs are displayed on the left.
3.
Highlight IP-CSs and click the right arrow to select them for registration. Click Next .
4.
If the registration is still in progress, the dialog box will show "Registration Executing".
If the registration is successful, the dialog box will show "Registration Completed". Click
Close .
Once the IP-CS is successfully registered, the status of the IP-CS will update to show "Registered".
De-registration
Follow the steps below to de-register the IP-CS.
1.
Click De-registration .
A dialog box will appear. Registered IP-CSs are displayed on the left.
2.
Highlight IP-CSs and click the right arrow to select them for de-registration. Click Next .
A dialog box will appear.
3.
Click Confirm .
If the de-registration is successful, the dialog box will show "De-registration Succeed".
4.
Click Close .
Once the IP-CS is successfully de-registered, the status of the IP-CS will update to show "None".
Forced De-registration
Follow the steps below to forcibly de-register the IP-CS when normal de-registration has been unsuccessful
or IP address settings have been changed or deleted only on the IP-CS.
1.
Click Forced De-registration .
A dialog box will appear. Registered IP-CSs are displayed on the left.
394 PC Programming Manual Document Version 2016-03
9.19 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Port Property