Panasonic KX-NS1000, Pc Programming Manual

Page: 1046 / 1294

24.3 UM Configuration—[5-3] System
Parameters—System Caller Name Announcement
Allows the System Administrator to store a maximum of 200 telephone numbers and record a caller name for
each telephone number. The caller name is announced when playing a message in their mailbox from one of
the pre-programmed callers, when the system transfers a call to the subscriber from one of the
pre-programmed callers (Caller ID Screening), and when the system pages the subscriber by intercom
(Intercom Paging).
Caller ID Screening feature is only available when the
Caller ID Screen parameter of the subscriber’s Class
of Service is set to "Yes". This feature is also enabled when subscribers select "Call screening" as the Call
Transfer method (see
20.1.15 Unified Messaging—Call Transfer Status in the Feature Manual).
The Intercom Paging feature is enabled by selecting "Intercom Paging" as the Call Transfer method (see
20.1.15 Unified Messaging—Call Transfer Status and/or 20.1.46 Unified Messaging—Incomplete Call
Handling Service in the Feature Manual).
Follow the steps below to edit System Caller Name Announcements.
Adding a Caller Extension and Description
1.
Specify the Caller-ID No. and Description for each entry that will be used.
2.
Click OK .
Editing Caller ID Entries
To edit an entry, select the desired mailbox group, then click the icon. You can also edit specific parameters
directly from the list.
Deleting Mailboxes
1.
Select an entry.
2.
Click the icon.
3.
Click Yes .
Recording a Name for the extension in the Caller Information dialog box
1.
Select the desired Caller ID number and click the icon.
Note
Before you can record, confirm that you have clicked Apply since you added the Caller ID No.
2.
Select "Record from extension" or "Import from recorded file".
When "Record from extension" is selected:
1.
Specify the extension number of the telephone used for recording, then click Connect .
2.
When the specified extension rings, go off-hook.
3.
Click Record , Play , or Stop to record or play a voice label through the extension.
4.
Click Disconnect .
5.
Click OK .
When "Import from recorded file" is selected:
1.
Click the folder icon.
The
Open dialog box appears.
2.
Navigate to the folder containing the WAV files you want to open.
WAV files must meet the following specifications:
–
G.711 PCM codec
–
8 kHz, 8-bit sampling rate
–
Monaural
–
A-law or µ-law encoding
3.
Select the desired WAV file.
1046 PC Programming Manual Document Version 2016-03
24.3 UM Configuration—[5-3] System Parameters—System Caller Name Announcement