3.2 Connecting IP-CSs
Connecting an IP-CS to a LAN
Notice
•
Connect the units to the LAN only after completing network settings.
•
When connecting a unit to the LAN, connect it to a switching hub.
Note
•
Use an Ethernet straight cable with an RJ45 connector to connect the unit to a switching hub. The
cable should be a 10BASE-T/100BASE-TX CAT 5 (Category 5) or higher cable, and the diameter of
the cable must be 6.5 mm or less.
•
It is possible to connect the unit to the LAN while registering the unit to the PBX.
1.
Connect the cable to the unit.
Ethernet Cable
2.
Pass the cable through the groove of the unit in one of the following three ways.
To a Switching Hub
To a Switching Hub
1
2
3
1
To a
Switching
Hub
3.
Connect the other end of the cable to the switching hub.
10
Quick Installation Guide
3 Installing the IP-CSs
