LED indicator
You can use the LED indicator to
confirm the keypad’s status.
Indicator
Status
Off
Normal operation, or
no power
Red,
blinking
slowly
Keypad is not
registered to a hub.
Red,
blinking
Keypad is out of range
of the hub.
Red,
blinking
quickly
Alarm system was
triggered.
Green,
blinking
slowly
Registration mode
(You pressed and held
M
N
)
Setup overview
1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Registration
Required only if the keypad was
purchased separately (i.e., not as
part of a bundle).
3
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
4
Installation
Install the keypad in the desired
location.
Registering the
keypad
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the keypad, it must
be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the
[Home
Network]
app.
Note:
R
Before registering the keypad, make
sure the AC adaptors of the hub and
keypad are connected and each
device is powered.
Using registration buttons
1
Hub:
Press and hold
M
OTHER
DEVICE
N
until the LED indicator
blinks slowly in green.
2
Keypad:
Press and hold
M
N
until the
LED indicator starts blinking slowly
in green and the touchpanel
buttons start blinking slowly.
R
When registration is complete,
the hub sounds one long beep.
Note:
R
To cancel without registering the
keypad, press
M
N
on the hub
and on the keypad again.
R
If registration fails, the hub sounds
several short beeps.
8
For assistance, visit www.panasonic.ca/english/support
Setup
HNK101C_(en_en)_0804_ver.030.pdf 8
2015/08/04 21:00:13
