Panasonic KX-HNC710W, Installation Manual

Page: 14 / 44

LED indicator Status
Green or amber, blinking
quickly - off for 1 second
Camera is on
*1
Amber, lit
Not registered to the access point *2 , or
signal level is good *3
Green, lit Registration successfully completed or
signal level is strong
*3
Green, blinking quickly
Camera is searching for an access point
*1
Red, lit
Registration failed, signal level is weak
*3
,
or detecting motion
*1
Red, blinking quickly
Streaming data
*1
Amber, blinking slowly
Battery is running low
*1
Green, blinking slowly Registration mode, updating
Red, blinking slowly Camera is out of range of the access
point
*1, *3
*1 You can configure the camera so that its LED indicator does not light
during normal operation. For more information, refer to the User’s
Guide (page 20).
*2 The LED indicator lights in amber for 5 seconds after the power is
turned on for the camera.
*3 The signal level (strong, good, weak, out of range) is shown after
pressing M SETUP N for 3 seconds.
Charging the
camera
R This camera has an internal
rechargeable battery.
R Remove the camera from the
wall before charging.
R Make sure to charge the
camera indoors and in a dry
location.
R Charge the camera in a location
with a temperature between
5 °C and 40 °C (41 °F and
104 °F). The camera cannot
14 For assistance, please visit http://shop.panasonic.com/support
Setup
HNC710_(en_en)_0207_ver.110.pdf 14 2018/02/07 20:11:47