Panasonic KX-FC255CX-S, Service Manual

Page: 72 / 256

72
KX-FC255CX-S
12.2. Error Messages-Display
If the unit detects a problem, one or more of the following messages will appear on the display.
The explanations given in the [ ] are for servicemen only.
12.2.1. Base Unit
• The back cover is open. Close the back cover firmly.
• The cordless handset you tried to call is in use.
The cordless handset you are calling is too far from the base
unit.
• [This error is displayed when the thermal head does not
warm up. Check the thermistor on the thermal head and
connector lead.]
• [This error is displayed when the gear is not in an idle state.
Check the GEAR BLOCK.]
(Refer to
Gear Section (P.186).)
• The document was not fed into the unit properly. Re-insert
the document. If misfeeding occurs frequently, clean the
document feeder rollers and try again.
(Refer to
Document feeder/recording paper feeder/scan-
ner glass cleaning (P.195).)
• The document is longer than 600 mm. Press [STOP] to
remove the document. Divide the document into two or more
sheets, and try again.
[Alternately, turn off service code #559 to enable sending of
documents longer than 600 mm] (Refer to
Service Function
Table (P.62).)
• The ink film is empty. Replace the ink film with a new one.
• The ink film is not installed. Install it.
• The ink film is slack or creased. Tighten it.
(Refer to step 5 on Installing the Ink film (P.52).)
• The recording paper is not installed or the unit has run out of
paper. Install paper and [SET] to clear the message.
• The recording paper was not fed into the unit properly.
(Refer to When the recording paper was not fed into the
unit properly (P.194).) Reinstall paper and press [SET] to
clear the message.
(Refer to
Installing the Recording Paper (P.54).)
• The recording paper has jammed near the recording paper
entrance. Remove the jammed paper and press [SET] to
clear the message. (Refer to Recording Paper Jams
(P.193).)
• See the other displayed message instructions to print out the
document.
Received documents are stored in memory due to a lack of
recording paper, a lack of ink film or a recording paper jam.
Install paper, install ink film or remove the jammed paper.
You will lose all faxes in memory if the power is removed.
Check with power connected. (Refer to
Installing the
Recording Paper (P.54) and Installing the Ink film (P.52)
and Recording Paper Jams (P.193).)
• The memory is full of received documents due to a lack of
recording paper, a lack of ink film or a recording paper jam.
Install paper, install ink film or remove the jammed paper.
You will lose all faxes in memory if the power is removed.
Check with power connected. (Refer to
Installing the
Recording Paper (P.54) and Installing the Ink film (P.52)
and Recording Paper Jams (P.193).)
• When performing memory transmission, the document being
stored exceeded the memory capacity of the unit. Send the
entire document manually.