16
Wall Mounting
Wall Mounting
1. Remove the wall mounting
adaptor from the unit as shown.
2. Set the operation board to level
1, then connect and secure the
telephone line cords.
•
The cords can also be run from
the top of the unit.
3. Attach the wall mounting
adaptor as shown.
•
Make sure the cords are not
pinched by the wall mounting
adaptor. When running the cords
from the top of the unit, look
through the opening in the wall
mounting adaptor
(
)
to
confirm that the cords are not
being pinched.
4. Drive the 2 screws (included)
into the wall either 83 mm or
100 mm apart, and mount the
unit on the wall.
Slide the wall
mounting adaptor
up to this point.
83 mm
100 mm
Washer
Drive the screw
to this point.
•
Make sure that the wall that the
unit will be attached to is strong
enough to support the unit
(approx. 1.65 kg [3.64 lb]).
•
Make sure the cords are
securely fastened to the wall.
•
When this unit is no longer in
use, make sure to detach it
from the wall.
Installing KX-DT301/KX-NT303
Installing KX-DT301/KX-NT303
1. Open the cover.
2. Attach the KX-NT303 to your
unit with the screws (included
with KX-NT303).
3. Plug the flat cable into the
connector ( ), then bend the
cable slightly as shown ( ).
4. Close the cover.
CAUTION:
•
To prevent damage to the telephone, be sure to unplug the
extension line before you set up or remove the KX-DT301 (USB
Module) or the KX-NT303 (Add-on 12 Key Module).
•
Connect the KX-NT303 first when installing both the KX-DT301
and the KX-NT303.
KX-NT303
The Add-on 12 Key Module allows 12
additional flexible buttons to be added to this
unit. These buttons are used to seize an
outside line, make a call using One-touch
Dialling, or perform a feature that has been
assigned to the key.
<with a KX-DT346>
LTD KT-DT300 Q_R_Guide_EN_FA.indd 16
7/14/09 8:51:02 AM