22 CIRCUIT OPERATION (HANDSET)
22.1. Outline
Handset consists of the following ICs as shown in BLOCK DIAGRAM (HANDSET) (P.61).
·
DECT BBIC (Base Band IC): IC1
−
−
−
−
All data signals (forming/analyzing ACK or CMD signal)
−
−
−
−
All interfaces (ex: Key, Detector Circuit, Charge, DC/DC Converter, EEPROM, LCD)
·
RF Module: IC10
−
−
−
−
PLL Oscillator
−
−
−
−
Detector
−
−
−
−
Compress/Expander
−
−
−
−
Amplifier for transmission and reception
·
Flash Memory: IC2
−
−
−
−
Program Code
·
EEPROM: IC3
−
−
−
−
Temporary operating parameters (for RF, etc)
22.2. Power Supply Circuit/Reset Circuit
Circuit Operation:
When power on the Handset, the voltage is as follows;
BATTERY(2.2 V ~ 2.6V: TP3)
→
+4V(4V)
→
IC10(6, 27), D20
→
IC1(35)
→
IC1(37, 22, 1, 84, 61) (2.65V)
The Reset signal generates IC1,C58 and 2.65V.
22.3. Charge Circuit
Circuit Operation:
When charging the handset on the Base Unit, the charge current is as follows;
DC+(5.5V ~ 6V)
→
D4
→
R43, R44
→
L4
→
(Base)
→
(Handset)
→
Q7
→
F1
→
... Battery
... BATTERY-
→
R14
→
GND
→
CHARGE-(Handset)
→
CHARGE-(Base)
→
GND
→
DC-(GND)
In this way, the BBIC on Handset detects the fact that the battery is charged.
The charge current is controlled by switching Q7 of Handset.
Refer to Fig.101 in Power Supply Circuit (P.59).
22.4. Battery Low/Power Down Detector
Circuit Operation:
"Battery Low" and "Power Down" are detected by BBIC which check the voltage from battery.
The detected voltage is as follows;
·
Battery Low
Battery voltage: V(Batt) < 2.3V
The BBIC detects this level and "
" starts flashing and "battery alarm" starts ringing.
·
Power Down
Battery voltage: V(Batt) < 2.2V
The BBIC detects this level and power down.
22.5. Speakerphone and Headset Jack
The hands-free loudspeaker at SP+ and SP- is used to generate the ring alarm. IC4 is used to switch off the telephone
loudspeaker and is used to amplify the signal to drive the hands-free loudspeaker. They are selected using the SP_AMP line
from pin 69 of the BBIC. 2.5mm headset jack is also available.
62
KX-TCD450RUM / KX-A145RUM / KX-TCD450R UT / KX-A145RUT
Summary of Contents for KX-A145 Series
