KC2S(AKC2)/KE2S(AKE2)
INSTALLATION
1. Panel installation
1. Panel installation
OPTIONS
EXPLANATION OF OPERATION
1) One-touch installation type
Note: When installing to a 4.5mm .177 thick panel, remove the
rubber spacer first.
2) Installation frame type
3) Panel cut-out dimensions
Rubber spacer
(attached)
Panel (thickness:
1 to 4.5mm
.039 to .177inch
)
Mounting screws
(attached to
mounting frame)
Mounting frame
ATH3803
(attached)
Panel (thickness:
1 to 4.5mm
.039 to .177inch
)
Rubber gasket
ATH3804
(attached)
45
+0.6
0
+.024
0
1.772
22.2
+0.3
0
+.012
0
.874
1) Installation using plastic magnet
Attach the unit to the equipment case.
2) Installation via double-sided tape
Use this method in places where a plastic
magnet cannot be used or where installation
strength is insufficient.
3) Installation via clamp
Clamp to one of the cables inside the
equipment, etc.
Note: Take careful note of the precautions for use in the catalog or user’s manual before using an Eco-COUNT METER or Eco-HOUR METER installed by one of the methods described above.
3. Terminal layout and wiring diagrams
(Common to Eco-COUNT METER and Eco-HOUR METER)
Notes: 1. Terminal
2
and
4
are connected inside.
2. The CT does not have polarity
4
CT input
1
2
3
Reset input
or
• Intermediate power cable (AKE2811)
200
±
10
7.874
±
.394
Note: We recommend using an intermediate power cable when attaching the dedicated CT to a non-“Y” split power cable
KC2S Eco-COUNT METER
1. The number of power-ons is counted by
sending through current through the
dedicated CT.
2. When the number of power ons
(measured value) reaches the full scale,
it reverts to 0, and starts counting again
from 0.
3. When the reset terminal input is set to
on, the display will read “0”. This does not
count during reset input.
4. Use the reset key on the front of the unit
to reset manually. The display will be blank
while the reset key is being pressed.
0
1
2
Full scale
ON OFF
∗
0
ON
1
2
0
1
OFF
Note:
∗
If reset input is shut off while CT through current is on, the count will be set to 1.
99999999
Reset input
Count value
Power on detection of
dedicated CT
!LL2IGHTS2ESERVEDÚ#
OPYRIGHT
0ANASONIC%LECTRIC7ORKS#O,TD
26/03/2013
