95
or the ID registration on the server. At the same time, each device has a default domain name (Generated
by MAC address) for your option. You can also use customized valid domain name (has not registered.).
3) Operation
Before you use Quick DDNS, you need to enable this service and set proper server address, port value
and domain name.
Server address
：
www.quickddns.com
Port number
：
80
Domain name
：
There are two modes: Default domain name and customized domain name.
Except default domain name registration, you can also use customized domain name (You can input your
self-defined domain name.) After successful registration, you can use domain name to login installed of
the device IP.
User name: It is optional. You can input your commonly used email address.
Important
Do not register frequently. The interval between two registrations shall be more than 60 seconds. Too
many registration requests may result in server attack.
System may take back the domain name that is idle for one year. You can get a notification email
before the cancel operation if your email address setup is OK.
4.11.1.4 UPnP
The UPNP protocol is to establish a mapping relationship between the LAN and the WAN. Please input
the router IP address in the LAN in Figure 4-88. See Figure 4-92.
Enable
：
Check the box here to enable UPNP function.
Status: When the UPNP is offline, it shows as “Unknown”. When the UPNP works it shows
“Success”
LAN IP: It is the router IP in the LAN.
WAN IP: It is the router IP in the WAN.
Port Mapping List
：
The port mapping list here is the one to one relationship with the router’s port
mapping setting.
List
：
Service name
：
Defined by user.
Protocol
：
Protocol type
Internal port
：
Port that has been mapped in the router.
External port
：
Port that has been mapped locally.
Default: UPNP default port setting is the HTTP, TCP and UDP of the NVR.
Add : Click it to add the mapping relationship.
Delete: Click it to remove one mapping item.
Double click one item; you can change the corresponding mapping information. See Figure 4-93.
Important:
When you are setting the router external port, please use port 1024~5000. Do not use well-known
port 1~255 and the system port 256~1023 to avoid conflict.
For the TCP and UDP, please make sure the internal port and external port are the same to
guarantee the proper data transmission.
Summary of Contents for k-nl304k
