NN-CT880MBPQ NN-CT870WBPQ
25
Note: After breaking off the motor cover, make sure that
cut-off portions are properly trimmed off or bent inside so
that no sharp edges are exposed.
Note: To secure the motor cover use a 4 x 6 screw.
10.8. Quartz Heater
1. Remove the sensor cable from the DPC connector CN7.
2. Remove the exhaust guide A by removing the two screws
shown in figure 10.
3. Disconnect the cables to the grill heater
4. Remove the grill cover by removing the 5 screws in figure
11
5. Remove the two screws holding the grill heater
(Figure12).
6. Loosen the 2 screws holding the ceramic grill holders,
turn the holders to release the grill element.
7. Remove the heater bracket D by using a flat blade screw
driver to lever back the tabs.
8. The grill element can now be removed from inside the
oven.
T
t
th t
t bl
t
Removing the exhaust guide and grill cover
Figure 10
Removing the Turntable motor cover
Figure 8
Two screws to remove the turntable motor
Figure 9
Summary of Contents for inverter NN-CT870WBPQ
