PAN9028 Wi-Fi/Bluetooth Module
10 Regulatory and Certi
Module Integration Guide Rev. 1.0
Page 35 of 45
RSS-247 Section
5.4
Frequency Band (MHz)
2 400 to 2 483.5
Systems
FHSs operating in the band 2 400 to 2 483.5 MHz.
DTSs employing digital modulation techniques operating in the band
2 400 MHz to 2 483.5 MHz.
Systems out of Scope
FHSs operating in the band 902 MHz to 928 MHz and 5 725 MHz to
5 850 MHz.
DTSs employing digital modulation techniques operating in the bands
902 MHz to 928 MHz.
Fixed point-to-point systems in the bands 2 400 MHz to 2 483.5 MHz and
5 725 MHz to 5 850 MHz.
Transmitters operating in the band 2 400 MHz to 2 483.5 MHz, may employ
antenna systems that emit multiple directional beams simultaneously or
sequentially.
Requirements
Transmitter Output Power:
The maximum peak conducted output power shall not exceed 1 W if the
hopset uses 75 or more hopping channels; the maximum peak conducted
output power shall not exceed 0.125 W if the hopset uses less than 75
hopping channels. The e.i.r.p. shall not exceed 4 W.
For DTSs employing digital modulation techniques operating in the band
2 400 MHz to 2 483.5 MHz, the maximum peak conducted output power shall
not exceed W. The e.i.r.p. shall not exceed 4 W.
Complied Module M/N
ENWF9408A1EF, ENWF9408A2EF
RSS-247 Section
5.5
Frequency Band (MHz)
2 400 to 2 483.5
System
In any 100 kHz bandwidth outside the frequency band in which the spread
spectrum or digitally modulated device is operating …
System out of Scope
-
Requirements
Unwanted Emissions:
In any 100 kHz bandwidth outside the frequency band in which the spread
spectrum or digitally modulated device is operating, the RF power that is
produced shall be at least 20 dB below that in the 100 kHz bandwidth within
the band that contains the highest level of the desired power, based on either
an RF conducted or a radiated measurement, provided that the transmitter
demonstrates compliance with the peak conducted power limits. If the
transmitter complies with the conducted power limits based on the use of root-
mean-square averaging over a time interval the attenuation required shall be
30 dB instead of 20 dB. Attenuation below the general field strength limits
specified in RSS-Gen is not required.
Complied Module M/N
ENWF9408A1EF, ENWF9408A2EF
