Panasonic HYBRID IP-PBX KX-TDA100, Installation Manual

Page: 409 / 428

8.1 Troubleshooting — KX-TDA30
Installation Manual 409
8.1.4 Using the Reset Button
If the Hybrid IP-PBX does not operate properly, use the Reset Button. Before using the Reset
Button, try the system feature again to confirm whether there definitely is a problem or not.
Notes
1.
When the System Initialise Switch is set to "NORMAL", pressing the Reset Button
causes the following:
• Camp-on is cleared.
• Calls on hold are terminated.
• Calls on exclusive hold are terminated.
• Calls in progress are terminated.
• Call park is cleared.
Other data stored in memory, except the above, are not cleared.
2.
When the System Initialise Switch is set to the "SYSTEM INITIALIZE" position, you
must press the Reset Button with caution, because all data stored in memory will be
cleared by the following operation: (1) pressing the Reset Button and then, (2) setting
the System Initialise Switch to the "NORMAL" position while the RUN indicator is
flashing (within approximately 10 s).
Operation
1.
If the Hybrid IP-PBX does not operate properly:
a.
Make sure that the System Initialise Switch is set to the "NORMAL" position.
b.
Press the Reset Button.
2.
If the Hybrid IP-PBX still does not operate properly:
a.
Set the System Initialise Switch to the "SYSTEM INITIALIZE" position.
b.
Press the Reset Button.
c.
Return the System Initialise Switch to the "NORMAL" position while the RUN indicator
is flashing (within approximately 10 s).
Note
As a result of Step 2, all the programmed data will be cleared.
Reset Button
System Initialise Switch
RUN Indicator
ALARM Indicator