Panasonic HYBRID IP-PBX KX-TDA100, Programming Manual

Page: 63 / 912

Note
With the KX-TDA600, the pair of cards to be used for the pair port tests must be installed within the same
shelf.
The tests that are performed are as follows:
Line current OFF (Ext->CO) Line current from extension to trunk turns off.
Line current ON (Ext->CO) Line current from extension to trunk turns on.
Off hook detection (CO->Ext) Off-hook generation/detection from trunk to extension
DTMF detection (CO->Ext) DTMF generation/detection from trunk to extension
DP detection (CO->Ext) DP generation/detection from trunk to extension
BELL detection (Ext->CO) BELL generation/detection from extension to trunk
Speech path (Ext->CO) Speech path from extension to trunk
Speech path (CO->Ext) Speech path from trunk to extension
To perform a pair port test
1.
From the Utility menu, select Diagnosis .
2.
Click on the Status cell of the extension card to be tested, and set it to "OUS".
3.
Click on the cell showing the card type.
A new window will be displayed.
4.
Select the Pair Port Test option.
A new window will be displayed. The card you selected in Step 3 will be shown in the Extension Line Slot
No. drop-down list.
5.
From the CO Line Slot No. drop-down list, select the slot number of the trunk card you want to test.
6.
From the CO Line Port No. drop-down list, select the port number of the trunk you want to test.
7.
Click Test .
The error report will be displayed.
8.
Select an option:
•
Click Capture if you want to save the displayed information.
1.
Enter a file name, or select a file to overwrite.
2.
Click Save .
•
Click Cancel to return to the Diagnosis screen.
Network Loopback Test (KX-TDA100/KX-TDA200/KX-TDA600 only)
Performs a remote loopback test on the PRI23 card.
Note
•
To perform this test, it is necessary to set Loopback Test started by Network in 3.16 [1-1] Slot
—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only) to "Enable".
•
The version of the PRI23 card must be 2.000 or later.
To perform a network loopback test
1.
From the Utility menu, select Diagnosis .
2.
Click on the Status cell of the PRI23 card, and set it to "OUS".
3.
Click on the cell showing the card type.
A new window will be displayed.
PC Programming Manual 63
2.6.1 Utility—Diagnosis