20
SQT0885 (ENG)
Setting date and time
The date and time setting of this unit is synchronized with that of the smartphone.
synchronize to adjust the clock, etc.
1
Tap
#
[Camera setup].
2
Tap [Date & time].
≥
When you want to adjust the clock, change the time of the smartphone first, and then synchronize
the time with this unit.
≥
It may take approximately 60 seconds to synchronize the time of the smartphone with that of this
unit.
≥
When the built-in battery of this unit runs down, the date and time setting returns to the default
state. Leave the built-in battery of this unit in a charged state for approximately 24 hours and the
date and time setting will be stored for approximately 4 months.
≥
The setting range from 1 January 2000 through 31 December 2039 is available for time
synchronisation with the smartphone.
Initializing the network settings
To reset the network settings to the default, after turning off this unit, press the power button (
l
16)
and recording start/stop button (
l
27) simultaneously to turn it on again and continue to hold them
down for approximately 3 seconds. When the Wi-Fi lamp flashes alternately in red and green, the
network settings are initialized.
≥
After initializing the settings, turn off and on this unit.
≥
The following settings will be reset to the default:
j
An SSID/Password for this unit set after the purchase
([Camera Wi-Fi settings]
#
[Camera SSID settings] in the “Image App”)
j
SSID/Password of Main Camera that was connected to this unit
HX-A1M-SQT0885_mst.book 20 ページ ２０１５年６月１日 月曜日 午前９時５８分
