39
VQT1N45
This unit will resume recording/pause mode about 0.6 seconds after the LCD monitor is reopened.
≥
When in quick start standby mode about 60% of the power used in recording pause mode is
being consumed, so the recording time will be reduced.
1
Select the menu. (
l
27)
2
Close the LCD monitor while the
mode switch is set to
.
The status indicator
A
flashes green and the unit
goes into quick start standby mode.
≥
The lens cover does not close.
3
Open the LCD monitor.
The status indicator
A
lights red and the unit is
put into recording pause approx. 0.6 seconds
after it is turned on.
≥
Set [QUICK START] to [OFF] to cancel the
quick start mode.
≥
Quick start standby mode is canceled if
j
about 5 minutes has elapsed
j
mode switch is set to
j
unit is turned off
≥
In the 24p digital cinema setting, the required
time for the quick start operation is slightly
longer than 0.6 seconds.
≥
In the quick start mode, it may take some time
for automatic white balance to adjust, if the
scene being recorded has a light source
different from the scene last recorded. (When
the MagicPix function is used, however, the
white balance of the scene last recorded is
retained.)
≥
In the quick start mode, the zoom
magnification becomes 1
k
and the picture size
may differ from what it was before quick start
standby mode.
≥
If [POWER SAVE] (
l
28) is set to
[5 MINUTES] and the unit automatically goes
into quick start standby mode, close the LCD
monitor and then open it again.
≥
If the unit is exposed to vibration or shock, the
time for the quick start mode to start may be
slightly longer than 0.6 seconds.
Quick start
[SETUP]
#
[QUICK START]
#
[ON]
HDCSD9P-VQT1N45_ENG.book 39 ページ ２００７年１２月２６日 水曜日 午後５時５７分
