Panasonic HD-PLC DA-PU100, Operating Manual

Page: 11 / 16

Number of terminal
adaptors Max. 1,024 units *3 per 1 MASTER unit
*1
The indicated value is the theoretical maximum. Actual speeds will be less than this
value.
*2
This value may differ based on the operating environment.
*3
The maximum number of terminal adapters may vary depending on the operating
environment.
Ethernet port
Physical interface IEEE 802.3 (10BASE-T) / IEEE 802.3u (100BASE-TX) /
Auto MDI/MDI-X / Auto Negotiation
Protocol TCP/IP (IPv4 / IPv6)
Access method CSMA/CD
Number of
connectable devices
Max. 8 devices per MASTER or TERMINAL adaptor *1
*1
This is the recommended number when using a switching hub.
RS-485 port
Standard EIA-485
Connection method Half-duplex
Max. cable length Max. 1,200 m (approx. 4,000 ft)
*1
Communication
speed 300 / 600 / 1,200 / 2,400 / 4,800 / 9,600 / 19,200 / 38,400 /
57,600 / 115,200 / 230,400 / 250,000 / 460,800 / 921,600 bps
*1
Response time The time "Command/Response communication time
*2
" with
"About 10 ms per hop" added.
Number of
connectable devices
Max. 31 slave units *3 per MASTER unit
Supported protocols Non procedural
Applicable AWG wire
value AWG28 – AWG16
*4
Appropriate torque to
clamp the wires 0.22 N·m – 0.25 N·m
*1
The communication distance and communication speed may vary depending on the
connected devices and operating environment. The communication distance and
communication speed may vary depending on the connected devices and operating
environment.
11