- 184 -
When the status indicator is flashing at a
particularly fast or slow rate, the following
should be considered.
Flashing with approx. 4 second period (off
for approx. 2 seconds, on for approx.
2 seconds):
≥
When the battery is over discharged or the
temperature of the battery is too high or low.
It can be charged, but it may take a few hours
to complete the charging normally.
≥
It will flash in approx. 2 second intervals
when normal charging resumes. Even in such
cases, it may start flashing in approx.
4 second intervals until charging is completed
depending on the conditions of use.
Flashing with approx. 0.5 second period (off
for approx. 0.25 second, on for approx.
0.25 second):
≥
The battery is not charged. Remove the
battery from the unit, and try charging again.
≥
Check that the terminals of the unit or battery
are not dirty or covered with a foreign object,
and connect the battery correctly once again.
If a foreign object or dirt is present, turn off
the unit before removing.
≥
The battery or environment is at an extremely
high or low temperature. Wait until the
temperature has returned to an appropriate
level and try charging again. If you are still
unable to charge, there may be a fault in the
unit, battery or AC adaptor.
Off:
≥
Charging has finished.
≥
If the status indicator stays off despite the
charging being unfinished, there may be a
fault in the unit, battery or AC adaptor. Refer
to page
for details on the battery.
When disposing of or giving away the SD
card, note that:
≥
Formatting and deletion of data on this unit or
computer only changes the file management
information and does not completely delete
the data in the SD card.
≥
It is recommended that the SD card is
physically destroyed or the SD card is
physically formatted using this unit when
disposing of or giving away the SD card.
To physically format the SD card, connect the
unit via the AC adaptor, select [SETUP]
#
[FORMAT MEDIA]
#
[YES] from the menu,
and then press and hold the recording start/
stop button on the screen below for about 3
seconds. When the SD card data deletion
screen appears, select [YES], and then follow
the on-screen instructions.
≥
The customer is responsible for the
management of the data in the SD card.
About status indicator during
charging
About the SD card