16
Installation
p
When installing the unit on a desk
Place the unit flat on the surface.
p
p
Install the unit in a stable location which will not be susceptible to shaking. If the unit is installed in a location which is
susceptible to shaking, this will cause the unit’s images to shake in turn.
p
p
Take care not to allow the unit to fall or otherwise be damaged during installation.
p
p
When carrying the unit, do not hold it by its head.
p
p
Do not take hold of the camera head or rotate it. Doing so may cause malfunctioning.
p
p
Take care not to pull the connected cables. Doing so may cause the unit to fall and/or it may result in injury.
Notes
Ensure that the unit will not fall off.
p
When mounting the unit on a tripod
Use a highly stable tripod which can bear the weight of the camera mounted on it.
Attach the tripod to the threaded hole for mounting the camera on the camera’s bottom panel.
Place the tripod on a completely flat and level surface.
Tighten the screw by hand to mount the tripod securely.
Do not tighten the screw by rotating the camera body. Doing so may cause malfunctioning.
Use screw for mounting the tripod that satisfy the following standard.
Screw for mounting tripod (1/4-20UNC)
4.5 mm to 6 mm
{3/16 inches to 7/32 inches}
p
p
Do not install the unit where people will be passing back and forth.
p
p
When using the unit mounted on a tripod, do not put the tripod high above the floor level.
p
p
Mount the unit securely so there is no looseness. Looseness may cause the unit to fall off and/or result in injuries.
p
p
When the unit is going to be used for a prolonged period of time, take steps to ensure that the unit will not topple or fall
over and that it will not fall off or fall down. After using the unit, restore the installation location to its original state without
delay.
Notes
