GA-M+
12
Part Names and Functions
2
Power port
Serial Number label
Power cord hook block
Back panel
Power port
Connect the supplied power cord to this port and connect the other end into an
electric outlet.
Power cord hook block
If the supplied power cord is hanged to this block, the cord becomes hard to pull
out from the power port.
Ground terminal
Only qualified personnel should install minimum 18AWG green-and-yellow stranded
copper wire to Ground terminal screw.
10/100/1000BASE-TX ports supporting PoE power supply (ports 1 - 4)
A PoE power supply which is IEEE802.3bt/at/af compatible is usable.
10/100/1000BASE-T terminals, hubs, repeaters, bridges, Ethernet Switches, etc. are
connectable. Lay out the twisted pair cables (CAT5e or higher) so that the cable lengths
fit within 100 m.
10/100/1000BASE-T port + SFP expansion slot (ports 5, 6)
SFP expansion modules can be mounted. (They are exclusively used with the twisted
pair ports.)
They automatically switch when the SFP expansion slots are linked.
Lay out the twisted pair cables (CAT5e or higher) so that the cable lengths fit within
100 m. The SFP ports only support full duplex.
Console port
Connect a VT100 compatible terminal, etc. with this port to configure or manage
this Ethernet Switch.
Console port
Ground terminal
Front panel
Transmission mode : RS-232C
Transmission speed : 9,600 bps
Stop bit
: 1 bit
Flow control
: None
Emulation mode
: VT100
Data length
: 8 bits
Parity control
: None
Transmission connector : RJ45
10/100/1000BASE-TX ports supporting PoE power supply
10/100/1000BASE-TX ports
SFP extension slot
