Slide 8
Quick Procedure To Check For Short or Low Resistance
Condition of the Vsus, Vda, and P15V Lines
1.
Make sure the TV is disconnected.
2.
Remove any residual charge from the Vsus and Vda
lines by momentarily grounding them through a 500
ohms resistor (At least 5Watts).
3.
Measure the resistance between chassis ground and
the pins indicated on the table below. A dead short or
a reading lower than 1K indicates a shorted or
partially shorted line.
Note:
Vsus
is generated by the Power supply and is only used by the SS and SC boards
Vda
is generated by the Power supply and is only used by the Panel (Panel Drive ICs)
P15V
is generated by the Power supply and is used by the A, SS, and SC boards
Test points for the Vsus, Vda, and P15V can be easily found on
the P board. To check for short circuit or low resistance on
these lines, follow this procedure:
TC-P42G25
Preparation
Voltage Test Points
Connector
/
Wire Color
Pin Number
Voltage
P11
/White
1
Vsus
P11
/
Brown
4
P15V
P35
/White
1
Vda
TC-P46G25
TC-P50G20 TC-P50G25
TC-P54G20 TC-P54G25
Note:
For a quick procedure to determine the cause of the problem
when a short or low resistance reading is found, see the next page.
For a detailed procedure, see pages 11~16
Summary of Contents for G20 Series
