4-4. Remote Programming
45
Using the FP Programmer II
The tools to be prepared ; FP Programmer II
;AFP1114, (or FP Programmer : AFP1112A or AFP1112)
FP Peripheral Cable ;AFP5520(0.5m) or AFP5523(3m)
1.Connect the FP Programmer II to the RS422 port on
the CPU using the FP Peripheral Cable.
2.Set the CPU to the PROG. mode.
Note :
3.Select the LINK number of home station using the
OP21 function.
Note :
[EXAMPLE]
4.Select the station number(UNIT NO.) of another
station using the OP20 function.
[EXAMPLE]
5.Then, modefy the program in the remote Programmable
Controller which hs been specified using the above
procedure.
Note :
• If the CPU is in the REMOTE mode, the mode can be remotely changed to either RUN or
PROG..
• The LINK number is assigned as “LINK 1”,
“LINK 2” or “LINK 3” starting with the unit
• If the AFP1112 type FP Programmer is
used, the setting of baud rate is required at
the CPU. Set the baud rate of the CPU to
19200 without fail.
O P - 2 1
2
ENT
(–)
OP
2
1
ACLR
READ
(HELP)
CLR
Enter the LINK number
with numeric keys.
WRT
1
2
3
,
or
O P - 2 0
2
ENT
(–)
OP
2
0
ACLR
READ
(HELP)
CLR
Enter the station number
(UNIT NO.)with numeric keys.
WRT
0
1
3
to
2
Summary of Contents for FP3
Page 102: ......
