Unpacking/
Installation
6-5
Location
Procedure
Check
7
8
Nut
A
Finisher bracket
Finisher
Feet
B
B
Finisher
Finisher
stand
Height adjustment
(1) Check the gap between the copier
and finisher and insure that the
gap is 0-0.5 mm.
(position A, front and rear)
(2) Confirm that the magnet catches
(front and rear) are touching to the
finisher brackets.
Adjust the height of the feet and fix
them by the nuts, if necessary.
Punch hole position adjustment
Before proceeding with this adjust-
ment, make sure that the copier’s
side to side registration is adjusted
properly.
Loosen the two screws of the
finisher bracket and move it front or
rear accordingly.
Note: If the height of the front foot
and rear foot is different from
each other (position B), this
adjustment may not be
performed correctly.