Panasonic Firetracker FT1020G3 CIE, Operation Manual

Page: 160 / 180

160
Operation Manual
FT1020G3 Rev 2.10.4
29.7 Synchronise the Control Units (H8/S7)
After any Control Unit restart in a network system, synchronisation will start automatically.
Synchronisation can also be started via EBLWin and this menu (H8/S7).
The Control Units must be synchronised when the following fault message is shown:
During the synchronisation, the following information will be displayed in all Control Units
in the system:
↻
(rotating clockwise) = Synchronisation in progress for the Control Unit (CU).
√ = Synchronisation completed successfully for the Cont rol Unit (CU).
<Blank> = Synchronisation failed for the Control Unit (CU).
Action Text in display Comments
"Menu" According to chapter
"Access", see page 42.
Scroll to menu H8. H8 Maintenance
"
↲
"
S1 Dis- / Re-connect loop / zone line input
S2 Acknowledge SERVICE signal
S3 Clear weekly average
S4 Test of alarm devices
S5 Safe shut down of control unit
S6 Activate address in alarm mode
S7 Synchronize the control units
S8 Activate / Reset outputs
Scroll to menu S7. S7 Synchronize the control units
"
↲
" Start synchronization? No
Yes
Press "▼", to select
"Yes". Press "
↲
" to start
the synchronisation.
"▼"
"
↲
"
Synchronisation in progress... During the
synchronisation, the
progress symbol for
each control unit is
shown.
In the example shown,
CU15 & CU16 are not
programmed.
CU00
↻
CU01
↻
CU02
↻
CU03
↻
CU04
↻
CU05
↻
CU06
↻
CU07
↻
CU08
↻
CU09
↻
CU10
↻
CU11
↻
CU12
↻
CU13
↻
CU14
↻
CU17
↻
CU18
↻
CU19
↻
CU20
↻
CU21
↻
CU22
↻
CU23
↻
CU24
↻
CU25
↻
CU26
↻
CU27
↻
CU28
↻
CU29
↻
After a while. Synchronisation completed
dd-mm-yyyy hh:mm
FAULT: Control unit xx has wrong information