E
NGLISH - 34
Settings
POSITION menu
If the projector is aligned non-perpendicularly to the
screen, or if the projection screen has an angled surface,
you can correct keystone.
Setting range: -32 to +32
You can move the projected image for fine adjustment.
Press
I
H
to move horizontally and
F
G
vertically.
If you have interference patterns of the projected image,
which is sometimes referred to as moire or noise, you
can minimize it by pressing
I
H
to adjust the clock
frequency.
If you require further adjustment for the same reason as
the
DOT CLOCK
adjustment, you can fine adjust the
timing of the clock. Press
I
H
to adjust.
You can switch the aspect ratio manually when needed.
Press
I
H
to cycle through the options.
Q
4:3
The input signal will be projected without any
change.
KEYSTONE
Image
Operation
NOTE:
• You can correct the distortion ± 30 degrees from the
plane. For a better quality image, installing the projector
with a minimum of distortion is recommended.
• Some distortion may be retained for lens shift
adjustment.
• The distortion of the
Main menu
screen is not
correctable.
• The result of the keystone correction will affect the
aspect ratio and the size of the image.
POSITION
Remote control
Control panel
See “Navigating through the MENU” on page 29.
See “Main menu and Sub-menu” on page 30.
POSITION
H
V
DOT CLOCK
NOTE:
• If the projecting signal’s dot clock frequency is higher
than 108 MHz, the adjustment may not make a
difference.
•
DOT CLOCK
needs to be adjusted before adjusting the
CLOCK PHASE
.
CLOCK PHASE
NOTE:
• If the projecting signal’s dot clock frequency is higher
than 108 MHz, the adjustment may not make a
difference.
•
CLOCK PHASE
is available with
PC
signals and the
following
COMPONENT
connection.
ASPECT
4:3
16:9
AUTO
S4:3