- 15 -
EN
3. Press the switch (B) OFF button after use.
[Fig.4]
CAUTION
• Read the instruction manual of the charger to
charge the battery pack, and how to handle
battery pack.
[Battery Pack]
For Appropriate Use of Battery Pack
• The rechargeable batteries have a limited life.
• For optimum battery life, store the Li-ion
battery pack following use without charging it.
For safe use
• The battery pack is designed to be installed
by proceeding two steps for safety. Make sure
the battery pack is installed properly to the
main unit before use.
• If the battery pack is not connected firmly
when the switch is switched on, the overheat
warning function and over-discharge
prevention function will be effectived that
safety operation is not possible, and the main
unit will not operate normally.
Connect the battery pack into the unit of the
tool until the red or yellow label disappears.
(There should be no more than a 15 °C
difference between the temperatures of the
battery and the charging location.)
[Battery charger]
Charging
CAUTION
1) If the temperature of the battery pack falls
approximately below
−
10 °C (14 °F),
charging will automatically stop to prevent
degradation of the battery.
2) The ambient temperature range is between
0 °C (32 °F) and 40 °C (104 °F).
If the battery pack is used when the battery
temperature is below 0 °C (32 °F), the tool
may fail to function properly.
3) Use the charger at temperatures between
0 °C and 40 °C, and charge the battery at a
temperature similar to that of the battery
itself.
4) When charging a cool battery pack (below
0 °C (32 °F)) in a warm place, leave the
battery pack at the place and wait for more
than one hour to warm up the battery to the
level of the ambient temperature.
5) Cool down the charger when charging more
than two battery packs consecutively.
6) Do not insert your fingers into contact hole,
when holding charger or any other
occasions.
7) To prevent the risk of fire or damage to the
battery charger.
• Do not cover vent holes on the charger
and the battery pack.
• Unplug the charger when not in use.
NOTE:
Your battery pack is not fully charged at the
time of purchase. Be sure to charge the battery
before use.
IV. MAINTENANCE
Before using
• To make any adjustments, changing
accessory, or storing this unit, remove battery
pack from this unit.
• To clean this unit, wipe with a dry, soft cloth.
WARNING
The battery pack must be removed from this
unit before it is scrapped.
How to empty dust cup [Fig.5]
1. Switch off the vacuum cleaner.
2. Remove the dust cup from the main unit
while pushing the button for attaching or
removing dust cup. (a)
3. Pull out the filter grid from the dust cup by
holding a tab. Shake the filter grid to remove
dust. (b)
• To make any adjustments, changing
accessory, or storing this unit, remove
battery pack from this unit.
• To clean this unit, wipe with a dry, soft
cloth.
4. Attach the filter grid into the dust cup again.
Pull out the dust filter. (c)
5. Empty the dust cup. (d)
6. Attach filters into the dust cup.
7. Fit the tab for fixing dust cup into the groove
of main unit, and attach the dust cup to the
main unit until it clicks. (e)
EY971037A302.indb 15
EY971037A302.indb 15
2018/05/29 15:37:21
2018/05/29 15:37:21
