background image

W0316GC0 -ST

 

J

Disposal

When discarding this product, please contact your local authorities or dealer and ask for 

the correct method of disposal.

Web Site : http://panasonic.net/avc/projector/

© Panasonic Corporation 2016

Panasonic Corporation

Replacing the air filter unit (continued)

Attention

 

z

Make sure that the main filter unit and the pre-filter are properly attached before using the 

projector. If they are not attached, the projector will suck in dirt and dust causing a malfunction. 

 

z

Dispose of the packaging materials properly after unpacking the product.

 

z

Do not disassemble the main filter unit.

Note

 

z

If you use the projector without attaching the main filter unit, the filter indicator blinks in red and 

the message appears on the projected image for about 30 seconds. Turn the projector off, and 

then attach the main filter unit before turning the projector on again.

 

z

The replacement cycle of the air filter units varies greatly depending on the usage environment.

 

z

For procedures on maintaining the air filter unit, refer to the operating instructions supplied with 

the projector.

Summary of Contents for ET-RFF200

Page 1: ...ructions and the projector operating instructions carefully and then use this product correctly Please save this Operating Instructions for future use Model No ET RFF200 Replacement Filter Unit Commercial Use Operating Instructions ENGLISH DPQX1007ZA X1 Main filter unit Pre filter ...

Page 2: ...ly sure to follow the procedure described in Switching off the projector in the operating instructions of the projector 2 Remove the air filter cover Fig 1 z z Pull out the air filter cover from the hook of the projector while slightly pushing upward the tabs of the air filter cover and open it in the direction of the arrow in figure z z When pulling open the air filter cover be sure to firmly hol...

Page 3: ... of the pre filter with the claws when attaching it Air filter cover Pre filter Claws Claws Fig 4 Fig 5 7 Attach the air filter cover to the projector z z Perform Step 2 in the reverse order to close the air filter cover and push in the air filter cover securely until it clicks into place 8 Connect the power plug set the MAIN POWER switch to ON and press the power button v b on the control panel o...

Page 4: ...dirt and dust causing a malfunction z z Dispose of the packaging materials properly after unpacking the product z z Do not disassemble the main filter unit Note z z If you use the projector without attaching the main filter unit the filter indicator blinks in red and the message appears on the projected image for about 30 seconds Turn the projector off and then attach the main filter unit before t...

Reviews: