10 - ENGLISH
Installing the brackets to the projector
After installing the projector mount bracket (sold separately) to the projector, install the
angle adjusting bracket
A
by following the procedure below.
As shown in the figure on the left, temporarily se
-
cure the angle adjusting bracket
A
to the projector
mount bracket with the 4 supplied captive washer
hex head bolts.
Note
z
The illustrations for the projector and the pro-
jector mount bracket may be different from real
products.
Suspending the projector
Angle adjusting bracket
B
Hooks
Angle adjusting bracket
A
1 Fit the hook of angle adjusting bracket
A
on the
captive washer hex head bolts which are tempo
-
rarily tightened in step 1 on page 8.
Attention
z
Do not remove your hands from the projector
until the captive washer hex head bolts of angle
adjusting bracket
B
are firmly hooked into the
L-shaped grooves.
WARNING
■
Mounting and installation must be
carried out by two or more persons.
Temporarily secure
in 2 places
Angle adjusting bracket
B
Angle adjusting bracket
A
2 Temporarily secure angle adjusting brackets
A
and
B
with the 2 supplied captive w-asher hex
head bolts as shown in the illustration on the left.
Attention
z
Make sure that the projector is horizontal when
temporarily tightening the fixing captive washer
hex head bolts.
Projector mount
bracket
Angle adjusting bracket
A
Temporarily
secure in 4
places.
Installation (continued)
