ENGLISH - 13
Adjusting the installation angle (continued)
■
If the picture is tilted to the right or left (horizontal tilt adjustment)
Hex nut retaining ceiling mount bolt
Loosen three captive
washer hex head bolts
each at the front and rear.
Adjustment
range ± 5°
Adjustable span
z
Adjust to the position where the picture is not
tilted by loosening the captive washer hex bolts
fixing the projector mount bracket and the angle
adjusting bracket (three locations in front and rear),
and rotating the projector.
z
Once the picture position has been set, be sure to
retighten the bolts securely.
Attention
z
Do not over-loosen the captive washer hex
head bolts, which are used to secure the angle
adjusting bracket to the projector mount bracket.
Otherwise, the projector may fall off.
Attention
z
After checking the position adjustments, check that the screws have been tightened to the torques specified on
page 6.
Note
z
If there is a keystone effect in the image even after adjusting the installation angle in the [POSITION] menu
of the projector without applying keystone correction, the positional relationship between the screen and the
projector is out of alignment. Check that the projector is facing the screen. Alternatively, perform the keystone
correction at the projector.
z
The wire rope is not shown in the illustration.
