Installing the Interface Board
8 - ENGLISH
How to install the Interface Board
Screws (4 locations)
Screws (4 locations)
Salient
Slot cover
Guide groove
Fig. 1
Fig. 2
Fig. 3
1) Remove the slot cover. (Fig. 1)
f
Remove the four screws fixing the slot cover of the projector by
rotating counterclockwise with a Phillips screwdriver. The removed
screws are used to fix the Interface Board.
f
When removing the fourth screw, hold the slot cover with your hand so
it will not fall.
f
To replace from other Interface Board, remove the Interface Board
following the procedure in “How to remove the Interface Board”
(
x
page 9).
2) Install the Interface Board to the projector. (Fig. 2)
f
Insert the guide groove of the Interface Board aligned to the salient of
the slot. Insert the bracket firmly all the way in.
3) Fix the Interface Board. (Fig. 3)
f
Tighten and fix with the four screws removed in Step
1)
.
Attention
f
The removed slot cover is required when the unnecessary Interface Board is removed. Store
it so it can be attached in the future.
ET-MDNDP10C_DPQX1381ZA_E.indb 8
2019/03/15 9:53:10
