6
7
Parts identification
(see fig. 1)
A
Protective cap
B
System outer foil
C
System outer foil release buttons
D
Foil frame
E
Inner blades
F
Foil frame release buttons
G
On/Off switch
H
-a
Battery capacity lamp
H
-b
Low battery indicator
I
Charge (status) lamp
J
Trimmer
K
Trimmer handle
L
Power cord
READ ALL INSTRUCTIONS BE-
FORE USE.
Charging and cordless
shaving
When charging the shaver for the first
time or when it has not been in use
for more than 6 months, charge it for
at least 8 hours before use.
Connect the power cord to the
shaver, and plug the power cord to
an AC outlet.
It will adjust automatically to voltages
between 100-240V AC.
In some areas, a special plug adap-
tor may be required.
The charge (status) lamp will glow
when the shaver is being charged. It
will flash when the charging is com-
pleted.
A full charge will supply enough
power for approx. 14 shaves (3 min-
utes per shave for a normal beard).
(For ES8017/ES8018/ES8019, see
fig. 2)
You should charge the shaver for 1
hour if the battery capacity lamp
blinks red. The battery capacity lamp
will glow in three colors depending
on its charge capacity level:
100% - 30%
: green
30% - 10%
: orange
less than 10%
: blinking in red
(For ES8016, see fig. 3)
You should charge the shaver for 1
hour if the low battery indicator glows.
Cord shaving
Connect the shaver to the AC outlet
and turn the shaver on.
If the shaver does not run, charge it
for approx. 1 minute.
Using your shaver
Caution – The system outer foil is
very thin and can be damaged if
handled improperly. Before each
use, always check the foil for dam-
age. To avoid personal injury, do
not use if the foil or other parts of
the shaving head is damaged.
Push the On/Off switch to turn the
shaver on. Hold the shaver at a right
angle (90
°
) to your skin (see fig. 4).
Start out shaving by applying gentle
pressure to your face. Stretch your
skin with your free hand and move
the shaver back and forth in the di-
7
10
g
h
i
f
d
e
j
b
c
a
