7
When charging
starts
When charging is
completed
10 minutes
after charging
is completed
Charge status lamp
glows.
The charge status
lamp blinks once
every second.
The charge status
lamp blinks once
every 2 seconds.
• If there is noise from radio or other source while using or charging
the clipper, move to a different location to use the clipper.
• The battery will deteriorate if not used for over 6 months, so
make sure to perform a full charge at least once every 6 months.
• The charging time may differ when using the clipper for the first
time, or if it has not been used for more than 6 months. The lamp
on the main body may not glow for several minutes when first
starting charging, but will glow when continuing to charge.
• Recommended ambient temperature for charging is
10 °C – 35 °C. The battery may not charge properly or not at all
under extreme low or high temperatures.
• When the charge status lamp is blinking rapidly (twice every
second), there is a charging malfunction. Please charge the
battery in the recommended ambient temperature range.
• 1 full charge will provide approximately 50 minutes of continuous
operation. (Based on dry using at 20 °C – 30 °C.)
The operating time may differ depending on the frequency of use
and the operating method.
• The battery used is a lithium‑ion, so charging after every use will
have no effect on battery life.
Charging without the charging stand
1. Press the power switch to turn off the power, and
insert the appliance plug into the clipper.
2. Plug in the adaptor into a household outlet.
AC operation
If you connect the AC adaptor to the clipper in the same way as for
charging, and turn on the power, you can use it.
• If the remaining battery is too low, the blades may move slowly
or stop, even with the AC operation. In this case, charge the
battery for 1 minute or more.
• The battery will be discharged, even with the AC operation.
Using the clipper
• Make sure that the clipper is turned off.
• The appliance may not operate in an ambient temperature lower
than approximately 5 °C.
1
1
Set the trimming height.
2
2
Press the power switch to turn on the power.
ER-GP81_AUS.indb 7
2017/10/11 13:59:22
