7
Engli
sh
How to use
• Clean the appliance after use.
1
Mount the head to the main body until it clicks.
2
Remove the protective cap and hold the main body so
as not to block the exhaust hole (
a
). (Fig. 3)
3
Turn on the power before putting the head in your nostril.
▪
Cut hairs using the tip of the outer blade (metallic part).
▪
The outer blade surface may get a little warm during use,
but performance will not be affected.
Note
• The use time after a full charge is as follows.
ER‑CBL1: 80 minutes
ER‑CBN1: 60 minutes
(Based on dry using at 20 °C – 30 °C)
The operating time may differ depending on the frequency of
use and the operating method.
Quick charge (ER‑CBL1 only)
Even though the battery runs out, you can use for 5 minutes
after 3‑minute charge.
(This will differ depending on usage.)
Removing and mounting
the head (Fig. 4)
• Make sure that the main body is turned off.
►
Remove
Remove the head while pushing the head release button (
b
).
▪
Stand the head when it is removed.
►
Mount
Mount the head to the main body until it clicks.
Trimming your nose hair and ear
hair (Fig. 5)
1
Insert the tip of the outer blade into your nostril or ear canal.
▪
Insert it slowly so as not to injure your nostril or ear canal.
2
Cut the nose hair and ear hair by moving the main body.
▪
Some trimmings may remain inside your nostril or ear canal
after cutting, so remove them using a tissue or similar.
Outlining your eyebrows,
moustache, or beard (Fig. 6)
1
Apply the tip of the outer blade to the hair (eyebrow,
moustache or beard) you would like to cut.
2
Cut the hair by moving the appliance slowly against the
direction of hair growth.
▪
You cannot trim the hair to length with this head.
▪
It is not suitable for the hair below 0.5 mm.
