EN11
Using the wheels to move the unit
After procedures 1 to 5 on page EN12;
1) Press the
button to return
the back rest to its original position.
2) Slide the power switch to the “off” position
and unplug the unit.
Place the controller
and the power cord
on the seat.
Hold the plastic part.
Mat, etc. Wheels
Do not hold here.
Doing so may result in dam-
age or injury.
Lift it no higher than waist height.
Connect the power cord to the unit
1) Check for dirt and damage on appliance inlet
of the power switch section and the
connector of the power cord.
2) Insert the connector into the appliance inlet.
3) Be sure to push the connector in all the way.
Appliance
inlet
Connector
English
Attach the controller holder and place
the controller into the controller stand.
1 Insert the controller holder into the controller holder
until it clicks in to place.
2 Fasten the controller stand with the controller holder
clamp screws.
3 Placing the controller into the controller stand.
•
Do not allow children to use the controller holder clamp screw.
Failure to observe this may result in accidental swallowing, or
accident or injury due to tampering.
WARNING
1
2
3
