Fig. 1
Bracket cover
Adaptor
(ST4.2X6)
Screw
Unit: inches (mm)
Adaptor
Tape
Damper
5
INSTALLATION (BETWEEN JOISTS MOUNTING)
Fan body
Red
Motor
White
LED lamp
Junction box
Black
Capacitor
(114 °C Fuse in Motor)
Thermally protected
White
White
White
White
Earth ground
White
Neutral
Neutral
Live
Live
Black
Black
Green
Green
Black
Black
Power Supply
AC 120 V 60 Hz
Power Supply
AC 120 V 60 Hz
WIRING DIAGRAM
IMPORTANT
Joist situation:
Spacing A is 12 inches
(305mm) to 24 inches
(609mm) on center joists
Joists
Remove the tape from damper and adaptor before
installation. As shown below:
Please follow the installation steps as below:
1. Insert the suspension brackets into the fan body
from each side of the bracket cover. (Fig. 1)
If spacing A between center joists is 12 inches,
cut all suspension brackets along the two “C”
cuts with a hacksaw or other tools.
Before
After
2-“C” cuts
UP
Ceiling
Suspension
bracket
Joist
Joist
Fan
body
Fig. 2
Suspension
bracket
>1/8 (3.2)
About 3/8 (9.5)
Long hole
Unit: inches (mm)
4-Long screws
(ST4.2X20)
joists
Fig. 3
4. Fix four long screws (ST4.2X20) partially into
joists at the four marked locations. (Fig. 3)
2. Fix suspension brackets and with screws
(ST4.2X6), but remember not to tighten the
screws up yet. (Except that the spacing is 12
inches between joists.) (Fig. 1)
3. Position the fan body between joists, and
hold it properly. Mark the long holes of all
the four suspension brackets on joists. (Fig. 2)
Suspension
bracket
Suspension
bracket
Gloves