Panasonic DT401, Maintenance Manual

Page: 4 / 38

2
SPECIFICATIONS
Item Specifications
Mounting angle
0 ° to 359 ° (It can be set in increments of 0.01°.)
Mounting range Refer to the Reference Manual.
Board flow direction Refer to the Reference Manual.
Control system Microcomputer system
External memory
Data is saved in PT. (Approximately 1 MB is required for saving a piece of data, depending
on the hard disk space of PT.) One type per 3.5-inch floppy disk
Program data
∗
1
Point count: Max. 10000 points
Machine body
Normal service source: Three-phase 200
±
10 VAC or 400
±
20 VAC
Frequency: 50/60 Hz
Power source
Power source
for HUB
∗ 3
Single-phase 100 VAC to 240 VAC
Machine body 1.5 kVA (Including a direct tray)
Rated capacity
Power source
for HUB
150 VA
Supply air pressure 0.49 MPa - 0.78 MPa (Downstream from MR unit: 0.49 MPa - 0.54 MPa)
Supply air volume 100 L/min (A.N.R)
Outside dimension 1260 mm (W) × 2722 mm (D) × 2000 mm (H) (Including PATLITE)
Mass
∗ 2
1600 kg (Standard configuration, excluding a collectively-changing truck)
Environmental
condition Temperature: 10 ° C to 35 ° C
Humidity: 25% to 60% (No condensation)
Transportation and
storage condition Temperature:
−
20
°
C to 60
°
C
Humidity: 75% (No condensation)
Altitude Less than 1000 m above sea level
Noise < 63 dB (A)
∗
1: PT prepares data. This machine can only modify some data.
∗ 2: Mass of the main body excluding the optional units
∗
3: The power supply for HUB is an option. This power supply is required when you wish to
communicate with PT while the main power supply is OFF.
E64C-E-MMA00-A01-01