22
VQT2X62
VQT2X62
23
Attaching the silicone jacket
Charging the battery
When using the camera in the mountains or close to water, the use of the supplied
silicone jacket is recommended to prevent the card/battery door or terminal cover
from opening unexpectedly.
●
Make sure that the power is off.
●
Attach the silicone jacket in a location with no sand or dust.
Securely attach the silicone
jacket to the camera
• Attach the silicone jacket carefully.
Forcibly attaching the jacket may
cause damage.
• Do not loop the hand strap through
the speaker hole.
Speaker hole
• Be sure to remove foreign objects (such as sand) and moisture (such as seawater)
from inside the silicone jacket. If they are not removed before attaching the silicone
jacket to the camera, they may scratch or dirty the camera. The recommended
procedure is to remove the silicone jacket from the camera, rinse it in water, and then
wipe off the water droplets with a soft and dry cloth.
■
Care after using the camera
• Remove the silicone jacket carefully from the camera. Forcibly removing the silicone
jacket may cause damage.
• Remove the camera from the silicone jacket and check carefully that no foreign
objects (such as sand) and moisture (such as seawater) are adhered to it.
• After rinsing the camera in water, wipe off the water droplets with a soft and dry cloth
and dry in a well ventilated and shaded area.
• Do not dry the camera with hot air, such as from a hair dryer. Deformation may make
the camera inoperable.
• Do not use soap, neutral detergents, or chemicals such as benzine, thinner, alcohol
or cleansers.
• After using the camera, remove the silicone jacket. Do not store the camera for a long
time while the silicone jacket is attached.
Always charge before first use!
(not sold pre-charged)
■
About batteries that you can use with this unit
It has been found that counterfeit battery packs which look very similar to the
genuine products are made available to purchase in some markets. Some of
these battery packs are not adequately protected with internal protection to
meet the requirements of appropriate safety standards. There is a possibility
that these battery packs may lead to fire or explosion. Please be advised that
we are not liable for any accident or failure occurring as a result of use of a
counterfeit battery pack. To ensure that safe products are used we recommend
that a genuine Panasonic battery pack is used.
•
Use the dedicated charger and battery.
•
The camera has a function for distinguishing batteries which can be used
safely. The dedicated battery supports this function. The only batteries
suitable for use with this unit are genuine Panasonic products and batteries
manufactured by other companies and certified by Panasonic. (Batteries which
do not support this function cannot be used). Panasonic cannot in any way
guarantee the quality, performance or safety of batteries which have been
manufactured by other companies and are not genuine Panasonic products.
Insert the battery terminals and
attach the battery to the charger
Ensure [LUMIX] faces outwards.
Connect the charger to the
electrical outlet
Charging light ([CHARGE])
On:
Charging in progress
(approx. 110 min. if fully
depleted)
Off:
Charging complete
If light is flashing:
• Charging may take longer
than normal if battery
temperature is too high or
too low (charging may not be
completed).
• Battery/charger connector is
dirty. Clean with a dry cloth.
●
Plug-in type
●
Inlet type
Battery
(model-specific)
Charger
(model-specific)
•
The AC
cable does
not fit
entirely into
the AC input
terminal. A gap will remain.
Detach the battery after charging is
completed