Preparation
17
VQT0U87
2
Insert:
Insert the card fully until it clicks
and it is locked.
Remove:
Push the card until it clicks, then
pull the card out upright.
• Check the direction of the card.
• Do not touch the connection terminals
on the back side of the card.
• The card may be damaged if it is not
fully inserted.
3
1
Close the card door.
2
Slide the card door to the end
and then close it firmly.
• If the card door cannot be completely
closed, remove the card and insert it
again.
• The card and the data may be damaged
if it is inserted or removed while the
camera is on.
• We recommend using Panasonic’s SD
Memory Card.
About the Built-in
Memory/the Card
∫
Built-in Memory [
]
You can record or play back pictures on
the built-in memory when you are not
using a card.
• The built-in memory capacity is about
14 MB.
• Picture size is fixed to QVGA
(320
k
240 pixels) when recording
motion pictures to the built-in memory.
(P55)
∫
Card [
]
You can record or play back pictures on
a card.
(The built-in memory cannot be used
when a card is inserted.)
∫
Access to the built-in memory or the
card
• The access indication lights red when
pictures are being recorded on the built-in
memory (or the card).
• Do not do the following when the access
indication lights, pictures are being read or
deleted or the built-in memory (or the
card) is being formatted (P78).
– Turn the camera off.
– Remove the batteries or the card (if
used).
– Shake or impact the camera.
– Disconnect the AC adaptor (DMW-AC6;
optional). (when using the AC adaptor)
The card or the data may be damaged and
the camera may not operate normally.
VQT0U87ENG.book 17 ページ ２００５年１２月２７日 火曜日 午後７時１２分
