13
(ENG) VQT4N67
1
Rinse with water with the side door closed.
•
After use at the seaside or underwater, soak the unit in fresh
water pooled in a shallow container for 10 minutes or less.
•
If the zoom button or camera [ON/OFF] button do not
press smoothly, it may be caused by an adhesion of
foreign objects. Using in such a state may cause
malfunctions, such as locking up, so wash off any
foreign objects by shaking the camera in fresh water.
•
Bubbles may come out of the drainage hole when you
immerse the camera in water, but this is not a malfunction.
2
Drain water by holding the camera upside-down
A
and
the right way up
B
and shaking it lightly a few times.
•
After using the camera at the beach or in water, or after washing it, water may remain around the
speaker and microphone for a while and may cause a drop in volume or sound distortion.
•
Make sure to put your hand through the strap to prevent the camera from falling.
3
Wipe off water drops on the camera with a
dry soft cloth and dry the camera in a
shaded area which is well ventilated.
•
Dry the camera by standing it on a dry cloth.
This unit incorporates drain design, draining
water in gaps in the camera [ON/OFF] button
and zoom button etc.
•
Do not dry the camera with hot air from dryer
or similar. Waterproof performance will
deteriorate due to deformation.
•
Do not use chemicals such as benzine, thinner, alcohol or cleanser, soap or
detergents.
4
Confirm that there are no water droplets, open the side door, and wipe off
any water droplets or sand left inside using a soft dry cloth.
•
Water droplets may adhere to the card or battery when the side door is opened without
thoroughly drying. Also, water may accumulate in the gap around the card/battery slot
or the terminal connector. Be sure to wipe any water off with a soft dry cloth.
•
The water droplets may seep into the camera when the side door is closed while it is
still wet, causing condensation or failure.
DMC-FT25&TS25GN-VQT4N67_eng.book 13 ページ ２０１２年１１月２１日 水曜日 午前１０時３６分
