Panasonic Digital Palmcorder PV-DV101, Manual

Page: 10 / 289

removed or dead, Error No. will not remain in the memory.)
5.1.4. SHORT JIG C.B.A.
(For early products)
Purpose of the Short JIG C.B.A.
In order to prevent the breaking of the Flash ROM due to ESD
(Electro Static Discharge), the Short JIG C.B.A. is installed to the connector B3 on the Main
C.B.A.
For early products, the Flash ROM has been used for DSC microcontroller (IC401) and System
Control microcontroller (IC6001).
When the Flash ROM is used for either or both microcontroller(s), be sure to attach the Short
JIG C.B.A. to the connector B3 on the Main C.B.A. (Otherwise, the comcorder can not be turned
on.)
For distinction, check whether the connector B3 is used on the Main C.B.A. or not.
When the B3 connector is on the Main C.B.A., the Flash ROM is used for either or both IC401 and
/or IC6001.
1. Open the LCD Unit.
2. Remove 2 Screws (A). Then open the Right Cover Unit.
3. Install the Short JIG C.B.A. to the Connector B3.
Fig. 3
5.1.5. REMOVAL/INSTALLATION OF F.P.C. FROM NON ZIF (Zero Insertion
Force) CONNECTOR
Removal/Installation of F.P.C. from the Non ZIF (Zero Insertion Force) connector:
1. To remove the F.P.C. from the Non ZIF connector, use the Plier for
Non ZIF Connector (LSVQ0028) to pull out the F.P.C. as shown.
The same Plier for Non ZIF Connector (LSVQ0028) should also be
10